Homepage / news / Technical Support / When the armature coil is partially burned, what method uses the DC generator to continue the generator
When the armature coil is partially burned, what method uses the DC generator to continue the generator
Views: 0 Author: Site Editor Publish Time: 2014-04-07 Origin: Site
A: The following methods can be used:
1. Pull the faulty coil is cut out from the two heads, and the upper layer is pressed to the bottom with bamboo sheet, and the upper layer is embedded around the new line, and the two ends of the new coil are soldered on the original copper sheet. .
2. Remove the joint of the burnout coil from the rectification, and then solder the short-circuit portion on the truffler in the first phase, so that the whole stream is short-circuited to all the coils. Removing the coil joint cuts some of the tied, don't make him loose.
3. Turn off the one-turn (or 匝) of a failed set of coils, weld the remaining coil ends on the rectifier of the response, and the method of shortening the coilgeneratorPower generation. my companygeneratorTechnical support hotline: 400-0991036
