Homepage / news / Technical Support / When the armature coil is partially burned, what method does the DC generator continue to power?
When the armature coil is partially burned, what method does the DC generator continue to power?
Views: 0 Author: Site Editor Publish Time: 2013-04-01 Origin: Site
The following methods can be used:
1. Pull the faulty coil is cut out from the two heads, and the upper layer is pressed to the bottom with bamboo sheet, and the upper layer is embedded around the new line, and the two ends of the new coil are soldered on the original copper sheet. .
2. Remove the joint of the burnout coil from the whole stream, and then weld the broken portion on the entire stream to weld the solder, which avoids the discontinuation of the oversupply. Removing the coil connector cuts some of the tied, don't make it loose.
3. Turn off the one-turn (or few turns) of a failed set of coils, and weld the remaining coils on the corresponding rectifier, and make the generator to generate electricity with a shortened coil. Details Contact Gu Xiaobing: 0991-3817210 0991-3814032 0991-3856119
