The failure of the conversion switch configured by the generator set occurred in those parts?

The failure of the conversion switch is most likely to occur in the contact portion, and the contacts are severely ablated due to the following reasons, so that the power is poor:

1. The start time is too long during operation, which makes large, small copper contacts and contacts overheat.

2, large, small copper contacts or insulating colloidal worn, causing non-steady contact, causing poor power generation, dual burning.

3, the rod return spring is soft, severely insufficient or maintenance of the contact group, the pressure of the copper disc and the contact between the contacts is small.

4. After the maintenance, the copper disk contact and the copper disk distance increase or improper assembly, and the installation is wrong.

5, the card circle on the rod, the opening washer falls off.

6, large copper disk center hole insulation washer damage, causing battery I to burn the spring.

7, four pairs of normally closed contact surface oxidation, resulting in poor power generation or short circuit of battery II charging circuit.

Jiangsu StarlightGenerator setThe technical support hotline in Xinjiang: 0991-3856119, 0991-3817210, 0991-3817210, 0991-3814032, 400-0991036