Star light generator set general control system description and identification method

Star light generator set general control system description and identification method
1 Description: A design advanced electronic control system is mounted on this generator set to control and monitor this unit. It is equipped with different control systems based on several different generators. They include HGM6100 series. HMG6300 Series and HGM6400 Series Self-starting systems.
An independent data file will be attached if a special control system is installed due to special needs.
The control screen provides a switchgester control to monitor its operation and output, or in an emergency, such as the oil pressure is low, or the high temperature of the coolant will be automatically stopped. Any series of installationgeneratorThe requirements are set.
The AC generator output circuit switch is that the circuit suddenly overload or the switch is automatically turned off to protect the output.
2. Identification: Any control system has a master, and is used by the controller's model on the housing of the master.
3. Control screen equipment: startgeneratorPrior to the group, the operator must be familiar with the instrument and components on the control screen. When the machine is running, the operator needs to observe the gaze instrument or the master display from time to time, so that the abnormal readings can be found to prevent problems.
If there is an additional additional device on the control screen, the control screen may be slightly different from the typical map of the plot. The following description will explain each device on the control screen (different models, may just be part of the device):
A) AC voltage meter - Voltage Meter Displays an output AC voltage of an alternator
B) AC Voltage Table Select Switch - Select Switch to provide the operator to select the voltage between or between the phase and the zero line, and the OFF position is to zero the operator when the operator is used to zero
C) AC current table - current table shows that the AC current is being conveyed and the size of this current is depends on the load, and the current is measured, and the current table selects the switch, such asgeneratorThe current meter cannot be read, and the current table selection switch may be in the OFF bit.
D) AC current table Select Switch - This switch can select the current of each phase and the OFF position can adjust zero when it is turned on.
E) Frequency table - The frequency table is used to display the frequency of the generator. When the diesel engine maintains a relatively stable speed under the control of the adjuster, the normal output frequency is 50 Hz or 60 Hz (generator full load), if only partial load, the frequency is slightly higher than normal, which is lowered by the governor The degree of determination. In fact, the frequency of no load should be 52 Hz or 62 Hz. When the load is connected, the frequency is lowered, and it should be 50 Hz or 60 Hz when loaded.
F) Running schedule - a table indicating how much time the generator is operating.
G) Diesel Water Temperature Table - A sensor thermometer connected to the engine is used to monitor the temperature of the engine coolant, and the normal operating temperature should be close to 85 Celsius (185F) different models of different model diesel engines. The working temperature is different, and should be \"Diesel Engine Manual \"
H) Diesel engine oil pressure gauge - a meter used to monitor generator hydraulic pressure, start working from the moment of diesel engine, normal oil pressure of about 35-60p, s, I / 60Hz.
I) Indicator Light-indicator indicates that the protection circuit is to be perceptually indicated that the red light indicates that the system will park, and the green light is on the power output.
J) The control switch has an emergency stop switch and a power switch.