Drying air into a generator

将generatorAll cover is removed for the escape of moisture air. During the drying process, the gas stream should be able to flow freely in the generator and take away moisture.
Please use two 1-3 kW hair dryers to import hot air from the air outlet from the generator. Pay attention to the heat source and the winding should maintain at least 300 mm to avoid overheating causes insulation damage.
Continuous heating and records an insulation resistance value every half an hour. When this value is as specified in the \"Typical Dry Curve \" section, the drying process has been completed.
Remove the heater and cover all the covers and re-trial.
If the unit does not run immediately, then make suregeneratorInstall anti-condensed heater and have been energized. Insulating the insulating resistance needs to be detected before the next run.
More about the technical issues of diesel generator sets, please call 24 hours technical support hotline 1899922000 13809953146 18609915083 0991-3814032 0991-3817210 0991-3856119