Description and maintenance method of starting battery in Xinjiang starlight generator set

1 Battery principle
1.1 Overall Description: Many batteries of the battery, including a plurality of metal sheets and electrolytes, which make metal plates produce chemical reactions, reversible when chemical reactions, it means that the battery can be repeated and discharged.
1.2 Electrolyte: These conductive liquids are diluted with a sulfuric acid solution in a lead-acid battery. It makes a chemical reaction to become a conductive medium.
1.3 Zealand: The specific gravity is a measurement unit that determines the concentration of sulfuric acid in the electrolyte compared to the weight of the electrolyte and water. At 25 degrees Celsius, a charged battery specific gravity should have 1.270, and the sulfuric acid solution is, the lower the specific gravity.
The chemical reaction reduces the specific gravity of sulfurous sulfurous sulfurized in the electrolyte when the battery is discharged. Therefore, this situation can be regarded as guidance of the charging condition.
1.4 Zerometer: The specific gravity can be measured directly with a specific gravity, which is a spherical water absorbent tube, which uses it to draw the electrolyte from the battery hub to the glass buoy in the specific gravity column in the scale marked. After adding water to the battery, do not instantly measure its specific gravity, to charge the battery to mix the water and the precipitated sulfuric acid so that the specific gravity of the measured is reliable, and there is, after the battery is maintained for a long time, after a long time starter Measurement specific gravity, its value is also higher than true value. The water formed in the motor during fast discharging will have no time and the electrolyte of the electrolyte on the motor. .
1.5 High or low temperatures: A battery with a specific gravity of 1.240 in the tropical climate (often above 32 degrees Celsius), which prolongs the life of the battery. If the battery is used in a low temperature environment, there will be no sufficient power supply start, because the sulfuric acid solution concentration is low. But this situation will not appear on the tropical climate. The battery for extremely cold climate uses a strong electrolyte, in some cases, in some cases, with a specific gravity of 1.290-1.300. When the specific gravity increases, the ability to cold start will also increase.
1.6 Temperature Correction: The specific gravity scale is the correction of 25 degrees, the specific gravity of the electrolyte, with the temperature above the above reference temperature, the specific gravity, 5.5 degrees per liter, 5.5 degrees per ratio of 50 degrees The degree reduction is 0.004.

2 maintenance of the battery
! In maintenance, wear an anticachpriopath and wear mask or goggles, once the electrolyte splashes on the skin or clothing, immediately rinse with a lot of water.
2.1 Injecting the electrolyte: The battery is done during transport, thus adding a mixed correct than heavy electrolyte. Take the plug into the top of each battery until 8 mm higher than the top edge of the metal sheet. Let the battery for 15 minutes. If you need to check and adjust the water level.
2.2di charges: In the injection of an internal electrolyte, the battery must be charged for 4 hours. According to the following current, this can be sufficiently mixed when the battery is mixed, such as the charging time is not enough to cause damage to the capacity of the battery. Battery model E017 Charging current is 9 amps, e012 charging current is 14 amps. The charging current is 20Amps. The above 4 hours of charging time may be as follows: If the battery deposit time exceeds 3 months, or the temperature exceeds 30 degrees or temperatures above 80% of 8 hours charging: such as battery storage time over one year with 12 hours.
If the charger current is inadequate, then lower current current can be, but it is not possible to reduce the above three, but the time is extended, (8 hours 7 ampsdaiti 4 hours 14 amps)
At the end of the charging time, check the water level of the electrolyte, if necessary, the correct specific gravity of the sulfite, the exhaust hole plug is placed in place.
10.2.3 Delivery: Normal operation and charging can result in some water to be evaporated, which requires no time to fill the battery from time to time.
First clean the battery to avoid dirt falling, then take the exhaust pore. Distilled water first until the split metal sheet divided sheet 8mm (5) places back the exhaust hole plug.
3 charging battery
! Make sure the battery is charged in a well-ventilated environment, there is no spark or open fire.
! Don't charge it anymore, the charger and no water.
! Remember to cut the charger before removing the joint.
Static (mainly) charger can be used to charge the battery, then the battery should be cut from the connection of the generator set, charge it with a foreign charger.