Assembly and assembly requirements of Kangming engine piston link
Views: 0 Author: Site Editor Publish Time: 2014-04-07 Origin: Site
Assembly and assembly requirements of Kangming i engine piston link set (1) assembly of the piston linkage parts 1 Before loading the dispersed parts into the assembly, it should be thoroughly cleaned and dried with compressed air. 2 The oil grade using the heat group mount heating should be the same as the engine oil used by the engine. 3_ When installing the plug pin ring, the two ends should remain in both ends, and the depth of the lock ring embedded in the ring tank should be larger than 2/3 of the diameter of the lock ring wire. 4 When the piston is assembled with the connecting rod, it should pay attention to the mark direction. 5 When assembling the piston ring, you should pay attention to the upward of the \"TOP \" in the loop side; the ring is not adjustable; the twisted ring is not reverse. 6 piston link groupGenerator setAfter the installation, the connection of the connecting rod is vertically closed on the center line of the piston skirt, and the method is less than 0.05 to 0.08 mm, which should be less than 0.05 to 0.08 mm. Technical support is less than 0.05 ~ 0.08 mm. Hotline: 400-0991036
